Hi
I have a problem... in a scene that I work with I have several objects.
If I use the button where I can change how objects are drawn, like wireframe, solid, solid outline etc some of my objects refuse to change draw mode.
Most of my object happily change mode to wire for instance. But a couple of them stubbornly remains in solid outline whatever mode I select...
What have I done and how can I undo this? Any suggestions is appreciated.
Some object refuses to change draw mode
-
compPanda
- Senior Chief Petty Officer
- Posts: 275
- Joined: 21 May 2009, 21:15
- Type the number ten into the box: 0
Some object refuses to change draw mode
-
v3rd3
- Lieutenant Commander
- Posts: 1191
- Joined: 21 May 2009, 20:04
Re: Some object refuses to change draw mode
Just a wild guess, is/are the object/s the current selection? If so, deselect and they should take the desired style.
-
Steinie
- Captain
- Posts: 2958
- Joined: 21 May 2009, 17:38
- Type the number ten into the box: 10
Re: Some object refuses to change draw mode
If you bring just one of the objects (a stubborn one) into a new scene by itself does the same thing happen?
-
stan
- Master Chief Petty Officer
- Posts: 584
- Joined: 21 May 2009, 17:20
Re: Some object refuses to change draw mode
could those objects be in object mode..right click the yellow sphere on corner of widget cage to bring toolbar up, then click on turn off object mode icon
-
compPanda
- Senior Chief Petty Officer
- Posts: 275
- Joined: 21 May 2009, 21:15
- Type the number ten into the box: 0
Re: Some object refuses to change draw mode
Thank you so much for the help everyone - stan was right. They where in object mode. Now I have managed to remove that so they work as they should.stan wrote:could those objects be in object mode..right click the yellow sphere on corner of widget cage to bring toolbar up, then click on turn off object mode icon
Thank you again!
