United3dArtists Archive

fahembree · Post by **fahembree** » 02 Jan 2011, 05:44

Trying to improve my tire modeling and here's the latest attempts.

MikomDude · Post by **MikomDude** » 02 Jan 2011, 11:38

Nice! Do you have any good tutorials?

Steinie · Post by **Steinie** » 02 Jan 2011, 14:52

Not too bad although I would deepen the tread slightly. The rim is not
too hot and takes away from your model. It sticks out away from the tire and
the spokes are not within the rim. It looks like a low profile/directional tire for high speeds
but the center is indented too much.

fahembree · Post by **fahembree** » 02 Jan 2011, 20:17

MikomDude wrote:Nice! Do you have any good tutorials?

I did the modeing in Hexagon, Is was my christmas gift to my self. You can find tutorials on the internet. The rim was one I created in TS a a couple of years ago.
I'm very pleased with hexagon and really surprised how much easier it is to model in thaa anyother 3d program I have tried. If fact on a scale of 1 to 10 hexagon would be a 10 and everything elase would score below a 5. Its really is that much better than anything else.

fahembree · Post by **fahembree** » 04 Jan 2011, 04:21

fahembree wrote:
MikomDude wrote:Nice! Do you have any good tutorials?
I did the modeing in Hexagon, Is was my christmas gift to my self. You can find tutorials on the internet. The rim was one I created in TS a a couple of years ago.
I'm very pleased with hexagon and really surprised how much easier it is to model in thaa anyother 3d program I have tried. If fact on a scale of 1 to 10 hexagon would be a 10 and everything elase would score below a 5. Its really is that much better than anything else.

Heres a link to the tutorial that I followered. It has no sound but it pretty straight foward. I'm sure the same can be done
in truespace using the bend icon.

http://ezbrush.blip.tv/file/1470299/"

United3dArtists Archive

Tire Test

Tire Test

Re: Tire Test

Re: Tire Test

Re: Tire Test

Re: Tire Test