Slicing Software

Post Reply
jeffroig
Chief Warrant Officer
Posts: 656
Joined: 22 May 2009, 10:49
Type the number ten into the box: 0

Slicing Software

Post by jeffroig » 12 Sep 2018, 16:39

Wanted to find out if anyone else has run into the same thing.
Using Cura you load your model and then setup all your parameters.
Upon doing so it tells you how long it will take to print.
When printing anything past 10 hours it is not correct.
Several prints have said 11 or 12 + hours but actually they are taking much longer.
..

Post Reply