Page 1 of 2

Korg Volca rack

Posted: 07 Feb 2016, 18:51
by splinters
My latest project is to get a full range of Korg Volca sound modules and make a rack to hold them all. I produced a template to cut out using the schools laser cutter and here is a render of what it all should look like.

Re: Korg Volca rack

Posted: 08 Feb 2016, 09:50
by bitkar
looking good... tho the shadows are a bit strange looking, i think.

Re: Korg Volca rack

Posted: 10 Feb 2016, 14:50
by Draise
I love this and the render is great!!!!!!! Though.. The scale is a bit. . Hard to get. Is it easy to reach the top back part? Is really nice. Do show the real thing once done!

Re: Korg Volca rack

Posted: 10 Feb 2016, 15:35
by splinters
Hmmmm, I had 'use environment light only' ticked....
I'd better try again. Draise, its quite small...I will look at the scale as its only about 450mm tall/deep.

Re: Korg Volca rack

Posted: 10 Feb 2016, 15:45
by Finis
Fine looking design. Both stylish and practical. The idea could be adapted to many uses.

Re: Korg Volca rack

Posted: 10 Feb 2016, 16:27
by splinters
Pencil should give a better sense of scale.

Re: Korg Volca rack

Posted: 10 Feb 2016, 17:27
by splinters
And in white.....

Re: Korg Volca rack

Posted: 11 Feb 2016, 00:35
by Draise
So cool!

Re: Korg Volca rack

Posted: 11 Feb 2016, 01:31
by clintonman
Pencil is a nice touch. When I first saw it without the pencil I thought ," How on earth can you reach that far!" :)

Re: Korg Volca rack

Posted: 27 Feb 2016, 09:41
by splinters
All done, opted for a four unit rack and sprayed it black as the edges were black from the laser cutter. I'm very happy with it and everything fits like a glove.