Technical questions, etc..
5 posts • Page 1 of 1
Is it possible to do this in Truespace? What steps do you take? Thanks!
I've drawn my path with the polygon draw tool and saved it in the macro library. When I macro\sweep it around the path I get two adjoining paths. There should be an opening for a dorway. Thanks!
- baseboard sweep.jpg (16 KiB) Viewed 723 times
I had my export settings wrong in Rhno 3d when I converted from dwg to dxf. I've been able to create baseboard but I'm still working on casing. Any suggestions?
- Posts: 4626
- Joined: 21 May 2009, 18:26
- Type the number ten into the box: 0
- Location: America!
I would make the casing and baseboards as separate pieces using a 2D profile and the sweep tool or lathe tool. I wouldn't try to use a path for sweeping.
You're not original -- a true individual. You only say what you're programmed to say. -- That Poppy
I found baseboard is best done with the path tool and casing is best done with the lathe tool.