Page 1 of 1
SDS behavior that doesn't make sense to me
Posted: 28 May 2010, 00:46
by trans ata
Hi.
I have an object like this:
and I want to add SDS to it. So I add an SDS layer, and it gives me this:
As you'll see, the edge loop that runs through the middle does something really funky instead of just smoothing out like the ones on the top and bottom do. Why is this, and how do I correct it?
tS 7.61 workspace side btw
Thanks!
Re: SDS behavior that doesn't make sense to me
Posted: 28 May 2010, 01:18
by clintonman
It looks like you may have some internal faces. Get rid of those and it should work ok.
Re: SDS behavior that doesn't make sense to me
Posted: 28 May 2010, 01:22
by trans ata
As you guessed, I've very new to this.
Thanks!
Re: SDS behavior that doesn't make sense to me
Posted: 28 May 2010, 02:18
by froo
yeah but you're making good progress!
Welcome to the forums Trans Ata!
Re: SDS behavior that doesn't make sense to me
Posted: 28 May 2010, 13:58
by Tommy
Welcome to our forum Trans Ata!
Re: SDS behavior that doesn't make sense to me
Posted: 30 May 2010, 13:11
by TransKim
Try to click SDS twice and check if thats what you want. Trans ATA
Re: SDS behavior that doesn't make sense to me
Posted: 30 May 2010, 18:22
by Prodigy
to avoid these kind of problems 2 tips.
1) move inside the object and start to delete internal faces.. just keep the external ones.
2) it looks like you have faces that are not joined on the verts, so use "weld elements tool"
willkommen aboard!
Re: SDS behavior that doesn't make sense to me
Posted: 31 May 2010, 07:38
by Tiles
Tip 3: use Modeler SDS. Modeler and Workspace SDS uses different algorithms. And this leads sometimes to other results. But beware of the bridge ...